www.virtualacorn.co.uk/forum

Hi All
Sometimes if I have been changing my Lan settings I get a problem trying to run VirtualRPC-Adjust.
I get the keycode screen asking for a correct code. If I shut the computer down and reboot it VA then loads ok (well it as done up to press).Is this a known problem and could it be 'fatal'.
Regards
JV

G'day John, whenever I have changed my network by changing/adding cards or other network devices, the keycode window pops up. It appears that registering VRPC is tied up with the network at the time you install. If you make a permanent network change you probably will have to get a new number.
Cheers, Alan

VA is installed on my laptop. It as a wired and wireless network. Maybe that is the problem i.e. there will be two MAC addresses which might confuse the VA keycode.
JV